Sennheiser e 901 Half-Cardioid Boundary Microphone for Kick Drums
₦558,307.42 Inc. VAT
Key Features
-
- For Kick Drum & Low-Frequency Instrument
- Half-Cardioid Boundary Condenser Mic
- Handles High SPL with Fast Attack
- Slip-Free, Dampening Rubber Pad
Available on backorder
The Sennheiser e 901 is a professional, condenser boundary microphone optimized for capturing kick drums, bass, and Leslie cabinets, and other low-frequency sound sources on stage or in the studio.
The e 901 features a capsule with an extremely thin, high-strength diaphragm that delivers exceptional signal reproduction with low bass response and fast transient signals without peak distortion.
The half-cardioid polar pattern eliminates unwanted noise and reflections from the mounting surface for a clean and present sound.
No stand is needed as the e 901 can be positioned inside a kick drum laying over a towel or pillow—close to the beater for picking up the attack. Alternately, it can also be used on a lectern, conference table, altar, theatrical stage, or pianos and percussion to capture full-bodied voice or instrument sound.
The mic is ruggedly constructed, with a slip-free rubber pad underneath so it will stay put.
Optimized Frequency Response
- The e 901 features a frequency response optimized for accurate reproduction of kick drums
High Sound Pressure and Fast Transient Reproduction
- The e 901 handles very-high sound pressure levels and reproduces fast attacks and transients without distortion
Half-Cardioid Pickup Pattern
- The half-cardioid pattern effectively rejects unwanted noise and reflection at the rear of the mic
Rubber Damping Plate
- The e 901 features a slip-free, dampening rubber pad at the bottom that absorbs vibrations
Other Features
- Integrated preamp
- Gold-plated XLR connector
- Powered via 48V phantom
Be the first to review “Sennheiser e 901 Half-Cardioid Boundary Microphone for Kick Drums”
You must be logged in to post a review.
Microphone
| Form Factor | Boundary/Surface Mount |
| Sound Field | Mono |
| Capsule | Electret Condenser |
| Polar Pattern | Half-Cardioid |
| High-Pass Filter | None |
Performance
| Frequency Range | 20 Hz to 20 kHz |
| Maximum SPL | 154 dB SPL |
| Impedance | 100 Ohms |
| Load Impedance | 1000 Ohms |
| Sensitivity | 0.5 mV/Pa |
Connectivity
| Output Connectors (Analog) | 1 x XLR 3-Pin Male (on Mic) |
Power
| Operating Voltage | 48 V (Phantom Power) |
Physical
| Mounting | Instrument Surface Mount |
| Dimensions | H: 1.04 x W: 4.13 x L: 4.98″ / H: 26.5 x W: 105 x L: 126.5 mm |
| Weight | 1.21 lb / 550 g |
Related products
Reviews
There are no reviews yet.